In terms of most models, the specific speed and speed matching are roughly as follows: the first gear corresponds to the engine at 2000-3000 rpm, and the speed is about 20-30 kilometers per hour;The second gear corresponds to the engine at 3000-4000 rh, and the speed is about 50-60 kilometers per hour.
What the poster is talking about may be the engine speed and speed handlebar of the motorcycle, that is to say, when the engine speed is 5000, the speedometer is 55 km/h. Instead of 50 km/h. If I understand correctly, it means that there is nothing wrong with your car. This is normal.
Take the common 125CC scooter as an example, when driving on a flat road, windless, light load and uniform speed, the engine speed is about 4500-5500 rpm/about, that is, about 5,000 rpm, which is not a very absolute speed, which will Driving conditions, vehicle conditions, road conditions, etc. vary and change.
1. Don't hurt the car, but often this It is also unbearable to run the engine at high load. The vehicle has passed strict inspection standards before leaving the factory. 5000 rvels is trivial, but you still have to cherish your own car.
2. The automatic transmission will cause certain damage to the engine at 5,000 rpm. In the starting state, the speed of the engine cannot be directly increased very high. In the starting state, the engine speed should be maintained between 2000-3000 rpm.
3. Is there a lot of automatic transmission 5000 conversion? Basically, it is not necessary, except for the time of vehicle inspection, because the vehicle will need to check whether the vehicle exhaust gas is qualified during the annual inspection. At this time, you need to step on the accelerator of the vehicle to the end, and the owner doesn't have to worry too much. It has no effect on the vehicle.
4. Automatic acceleration of 5000 will cause certain damage to the engine. In the starting state, the engine speed cannot be directly increased for 10 minutes. In the starting state, the engine speed must be maintained between 2,000 and 3,000 rm.After the car starts smoothly, the engine speed can be increased at this time.
5. The automatic transmission throttle 5000 turns does not hurt the car according to the actual situation. If the vehicle is in P gear and the engine of the car reaches 5,000 rPM, it will not hurt the car too much, but it will wear out the engine, but within a reasonable range.
6. In different gears, the speed of the vehicle reaches 5000 rpm, which has different impacts on the vehicle. The owner can refer to the following situations. If the vehicle is in P gear and the engine of the car reaches 5,000 rPM, it will not hurt the car too much, but it will wear out the engine, but within a reasonable range.
It depends on the displacement of the car.Generally speaking, the speed of a family car is 80 km/h, and the engine speed should be kept between 2000-2500 rm. For engines with a displacement of 4T, it is normal for the engine speed to be about 2000rpm, and the engine speed at idle can generally be maintained between 700rpm and 1000rpm.
This depends on the displacement of the car. Generally speaking, the speed of a family car is 80km/h, and the engine speed should be kept between 2000-2500 rpm.
This speed is not a big deal compared with this speed. It's normal. You should know that SUVs are generally not high-speed, and 3000 to 110 is reasonable. If it is confirmed that the same car is faster than yours at 2000 revs, it is also because he changed the tire or the clutch of your car slipped. This is the hard connection transmission ratio, which has nothing to do with carbon accumulation.
Hello, the speed of 80 miles and the speed of 5000 indicates that the clutch has slipped. I hope my answer can help you! [ If there is a problem with the car, ask the car master. 4S store professional technician, 10 minutes to solve.
Hello, it's not normal. Generally, the 5th gear runs 80, and the normal speed of the engine is about 2000 to 2200. The lower the speed, the better the engine. I hope I can help you.
It is normal to have a speed of 80 and a speed of 2000. For family cars, when the driving speed of the car is maintained at 80km/h, the engine speed will not exceed 2500 rm. For example, in a 6L automatic transmission car, the engine speed will basically remain below 2,500 rm.
Enhanced due diligence via HS code-APP, download it now, new users will receive a novice gift pack.
In terms of most models, the specific speed and speed matching are roughly as follows: the first gear corresponds to the engine at 2000-3000 rpm, and the speed is about 20-30 kilometers per hour;The second gear corresponds to the engine at 3000-4000 rh, and the speed is about 50-60 kilometers per hour.
What the poster is talking about may be the engine speed and speed handlebar of the motorcycle, that is to say, when the engine speed is 5000, the speedometer is 55 km/h. Instead of 50 km/h. If I understand correctly, it means that there is nothing wrong with your car. This is normal.
Take the common 125CC scooter as an example, when driving on a flat road, windless, light load and uniform speed, the engine speed is about 4500-5500 rpm/about, that is, about 5,000 rpm, which is not a very absolute speed, which will Driving conditions, vehicle conditions, road conditions, etc. vary and change.
1. Don't hurt the car, but often this It is also unbearable to run the engine at high load. The vehicle has passed strict inspection standards before leaving the factory. 5000 rvels is trivial, but you still have to cherish your own car.
2. The automatic transmission will cause certain damage to the engine at 5,000 rpm. In the starting state, the speed of the engine cannot be directly increased very high. In the starting state, the engine speed should be maintained between 2000-3000 rpm.
3. Is there a lot of automatic transmission 5000 conversion? Basically, it is not necessary, except for the time of vehicle inspection, because the vehicle will need to check whether the vehicle exhaust gas is qualified during the annual inspection. At this time, you need to step on the accelerator of the vehicle to the end, and the owner doesn't have to worry too much. It has no effect on the vehicle.
4. Automatic acceleration of 5000 will cause certain damage to the engine. In the starting state, the engine speed cannot be directly increased for 10 minutes. In the starting state, the engine speed must be maintained between 2,000 and 3,000 rm.After the car starts smoothly, the engine speed can be increased at this time.
5. The automatic transmission throttle 5000 turns does not hurt the car according to the actual situation. If the vehicle is in P gear and the engine of the car reaches 5,000 rPM, it will not hurt the car too much, but it will wear out the engine, but within a reasonable range.
6. In different gears, the speed of the vehicle reaches 5000 rpm, which has different impacts on the vehicle. The owner can refer to the following situations. If the vehicle is in P gear and the engine of the car reaches 5,000 rPM, it will not hurt the car too much, but it will wear out the engine, but within a reasonable range.
It depends on the displacement of the car.Generally speaking, the speed of a family car is 80 km/h, and the engine speed should be kept between 2000-2500 rm. For engines with a displacement of 4T, it is normal for the engine speed to be about 2000rpm, and the engine speed at idle can generally be maintained between 700rpm and 1000rpm.
This depends on the displacement of the car. Generally speaking, the speed of a family car is 80km/h, and the engine speed should be kept between 2000-2500 rpm.
This speed is not a big deal compared with this speed. It's normal. You should know that SUVs are generally not high-speed, and 3000 to 110 is reasonable. If it is confirmed that the same car is faster than yours at 2000 revs, it is also because he changed the tire or the clutch of your car slipped. This is the hard connection transmission ratio, which has nothing to do with carbon accumulation.
Hello, the speed of 80 miles and the speed of 5000 indicates that the clutch has slipped. I hope my answer can help you! [ If there is a problem with the car, ask the car master. 4S store professional technician, 10 minutes to solve.
Hello, it's not normal. Generally, the 5th gear runs 80, and the normal speed of the engine is about 2000 to 2200. The lower the speed, the better the engine. I hope I can help you.
It is normal to have a speed of 80 and a speed of 2000. For family cars, when the driving speed of the car is maintained at 80km/h, the engine speed will not exceed 2500 rm. For example, in a 6L automatic transmission car, the engine speed will basically remain below 2,500 rm.
Trade data-driven supply chain optimization
author: 2024-12-23 23:18APAC special tariff HS code listings
author: 2024-12-23 22:46Global trade intelligence whitepapers
author: 2024-12-23 22:25HS code integration in digital customs systems
author: 2024-12-23 22:19Real-time commodity flow tracking
author: 2024-12-23 21:57HS code alignment with import licensing
author: 2024-12-23 23:59How to evaluate free trade agreements
author: 2024-12-23 23:41HS code intelligence for oil and gas industry
author: 2024-12-23 23:37Trade data analysis for small businesses
author: 2024-12-23 23:06Paper and pulp HS code insights
author: 2024-12-23 23:05556.24MB
Check457.75MB
Check567.33MB
Check987.21MB
Check396.19MB
Check939.74MB
Check414.55MB
Check188.26MB
Check498.12MB
Check727.32MB
Check699.73MB
Check439.75MB
Check371.81MB
Check294.78MB
Check582.96MB
Check887.29MB
Check643.24MB
Check876.55MB
Check536.79MB
Check685.48MB
Check933.14MB
Check538.91MB
Check124.77MB
Check998.18MB
Check893.47MB
Check631.41MB
Check849.39MB
Check377.79MB
Check192.93MB
Check252.78MB
Check349.58MB
Check318.95MB
Check384.34MB
Check442.39MB
Check921.66MB
Check291.56MB
CheckScan to install
Enhanced due diligence via HS code to discover more
Netizen comments More
2797 Global trade lead generation tools
2024-12-24 00:17 recommend
162 Frozen goods HS code classification
2024-12-24 00:15 recommend
166 Trade data-based price benchmarks
2024-12-24 00:14 recommend
583 HS code alignment with labeling standards
2024-12-23 23:29 recommend
57 How to secure international sourcing
2024-12-23 22:55 recommend